2010 F150 Passenger Fuse Box Diagram

This automotive "how-to" guide was specifically written to assist owners of the 12th generation (2009, 2010, 2011, 2012, 2013 & 2014) Ford F-150 truck in checking or replacing an electrical fuse in either the engine bay or passenger compartment fuse boxes.

Owners of other F-Series trucks or other Ford, Lincoln and Mercury vehicles such as the Super Duty F-250, F-350, F-450, Expedition, Explorer, Edge, Escape, E-150, E-250, E-350, Transit Connect, Flex, MKX, MKT, Navigator and Mountaineer may also find these DIY instructions to be helpful.

Assortment boxes of new low profile mini blade fuses in a variety of amperage ratings (E.G. 5, 10, 15, 20) can be bought at various retailers such as Wal-Mart, Pep Boys, Advance Auto Parts or online at Amazon.

A white plastic fuse puller tool should be attached to the back of the passenger compartment fuse panel cover.

You can also use a pair of needle nose pliers to remove a fuse.

This 2013 Ford F-150 is equipped with the Coyote 5.0L V8 motor and the fuse panel is located at the front center of the engine bay in a rectangular black box. The fuse box location may be different for other engine options of the 12th generation F150.

To open the fuse box cover, press the two buttons on the front and swing open the cover towards the rear of the engine bay.

There is a fuse location diagram on the underside of the cover and also in the owner's manual.

The passenger compartment fuse box is located beneath the right side kick panel in the front passenger foot well. Gently pull off the kick panel to reveal the rectangular fuse box cover.

Squeeze together the two sides of the fuse box cover and gently pull it straight off the panel.

The white plastic fuse puller tool should be attached to the back side of the interior fuse box cover. There is a fuse location diagram on the back of the cover and also in the owner's manual.

If the white plastic fuse puller tool is missing, you can also use a pair of needle nose pliers to remove a fuse.

Squeeze together the end of the fuse puller tool to open the jaws and place them over the fuse you want to check before pulling it straight out of the panel.

To check if the fuse is "blown", hold it up to a light source.

If the thin metal strip inside the plastic center part of the fuse appears to be broken, the fuse is "blown" and needs to be replaced.

If the metal bar inside the fuse is intact, the fuse is probably still good. Since new fuses are so inexpensive, it should still be replaced as part of your electrical problem troubleshooting process.

Make sure that the new fuse is the same amperage rating (E.G. 5, 10, 15, 20).

Push the new low profile mini blade fuse straight in to the socket.

Swing the engine bay fuse box cover closed towards the front of the truck and push it down to secure the two clips.

Replace the white plastic fuse puller tool on the back of the interior fuse panel cover and gently snap it back in to place.

Push the passenger foot well kick panel back in to place.

For more, check out my other Ford F-150 Repair & Maintenance Guides.

Posted by: loraleeloraleecraile0274327.blogspot.com

Source: https://www.paulstravelpictures.com/Ford-F150-Electrical-Fuse-Replacement-Guide/